Preparing the power supply
31
Preparing the power supply
z
To ensure a steady and uninterrupted power supply for the device during
operation, we recommend the use of a separate UPS. For details about the
UPS installation protocol, consult the UPS supplier.
z
We recommend that the required power supply of the UPS be no less than
3 kVA (including the power supply of the server). Connect the power cord
of the device to the output port of the UPS.
z
Ensure that the voltage meets the requirement to prevent poor
performance of electric components. Failure to do so might damage
electrical components.
z
If a UPS is connected to the device, connect the UPS to the mains supply.
Otherwise, connect the device to the mains supply directly.
The following list describes the power specifications:
z
Voltage and frequency range: 100 V to 240 V
~
, 50/60 Hz
z
Voltage fluctuation:
±
10%
z
Rated power: 1200 VA
z
Grounding resistance: less than 4 Ω
z
Transient over-voltage category: II
Preparing peripheral devices
Prepare the following peripheral items:
z
MGIDL-200H Portable DNB Loader: we recommend that you use
the portable DNB loader of the manufacturer. For details, refer to
relevant guide.
z
Library preparation system: we recommend that you use the
library preparation system of the manufacturer.
z
Ultra-pure water machine: general laboratory supplier.
z
Frost-free freezers or refrigerators: three temperature ranges: 2 ℃
to 8 ℃ (35.6 ℉ to 46.4 ℉ ), below -18 ℃ (-0.4 ℉ ), and below -70
℃ (-94 ℉ ).
Preparing DNBs
We recommend that you use the library preparation system or
library preparation reagent kit of the manufacturer to prepare DNBs.
For details, refer to relevant user manuals.
To Next Page
Loading...