MGI DNBSEQ-G400 - Sequencing Workflow; Logging in

Sequencing
36
Sequencing workflow
The sequencing workflow is as below:
Perform a wash
Review parameters
Load the DNB, reagent cartridge, and flow cell
Log in
Start sequencing
Perform a pre-run wash
z
Chemicals in reagents and waste might cause personal injury through
contact with the skin, eyes, and mucosa. Follow the safety standards of
your laboratory and wear protective equipment (such as laboratory coat,
protective glasses, mask, and gloves) when performing a sequencing run.
z
When the waste reaches two thirds of the maximum volume before
sequencing, or when the waste icon turns red during sequencing, we
recommend that you empty the waste container. Dispose of the waste
according to local regulations and your laboratory safety standards. Wear
protective equipment (such as laboratory coat, protective glasses, mask,
and gloves) when handling the waste. Personal injury might be caused by
contact with the skin, eyes, and mucosa.
Logging in
You can perform the sequencing and wash procedures only after you log in
to the control software.
Perform the following steps:
1. Power on the device.
2. Log in to the computer with the password that is provided by the
manufacturer.
3. Tap in the main interface.