Microhard Systems pX2 - Page 108

© Microhard Systems Inc. 108
5.0 AT Command Line Interface
AT+MCPS2
Command Syntax (Effect: AT&W)
Configure the Serial port as either a console port
(AT Commands) or a Data Port.
AT+MCPS2=<Mode>
Mode:
0 Console
1 Data
Description
Example
Input:
AT+MCPS2=0<enter>
Response:
OK
AT+MCBR2
Command Syntax (Effect: AT&W)
Get/Set Serial port baud rate.
AT+MCBR2=<Baud Rate>
Baud Rate:
0 300
1 600
2 1200
3 2400
4 3600
5 4800
6 7200
7 9600
8 14400
9 19200
10 28800
11 38400
12 57600
13 115200
14 230400
15 460800
16 921600
Description
Example
Input:
AT+MCBR2=13<enter>
Response:
OK
AT+MCDF2
Command Syntax (Effect: AT&W)
Get/Set Serial port data format
AT+MCDF2=<data format>
Data Format:
0 8N1
2 8E1
3 8O1
Description
Example
Input:
AT+MCDF2=0<enter>
Response:
OK