Microhard Systems pX2 - Page 129

© Microhard Systems Inc. 129
5.0 AT Command Line Interface
ATL <enter>
AT Commands available:
pX2-Test> ?
Help Show available commands
History Show a list of previously run commands
Info System info
Status Display the system status
System Setting system configurations
Network Set or Get network config
AT AT Echo OK
ATE0 Disable Echo
ATE1 Enable Echo
AT+TEST AT Echo TEST
ATH Show a list of previously run AT commands
ATL List all available AT commands
AT&R Reserved
AT&V Display modem active profile
AT&W Enable configurations you have been entered
ATA Quit
ATO Quit
AT+MSCNTO Get/Set console timeout
AT+MSPWD Set password
AT+MSGMI Get manufacturer Identification
AT+MSSYSI Get system summary information
AT+MSGMR Get modem Record Information
AT+MSMNAME Get/Set modem Name Setting
AT+MSRTF Reset the modem to the factory default settings of from non-volatile (NV) memory
AT+MSREB Reboot the modem
AT+MSNTP Get/Set NTP server
AT+MSSYSLOG Get/Set syslog server
AT+MNLAN Show/Add/Edit/Delete the network LAN interface
AT+MNLANDHCP Get/Set LAN DHCP server running on the Ethernet interface
AT+MNIPMAC Show/Add/Delete/Release/ReleaseAll the MAC-IP address binding
AT+MNEMAC Get the MAC address of local Ethernet interface
AT+MNPORT Get/set the Ethernet port configuration
AT+MCPS2 Get/Set Serial port
AT+MCBR2 Get/Set Serial port baud rate
AT+MCDF2 Get/Set Serial port data format
AT+MCDM2 Get/Set Serial port data mode
AT+MCCT2 Get/Set Serial port character timeout
AT+MCMPS2 Get/Set Serial port maximum packet size
AT+MCNCDI2 Get/Set Serial port no-connection data intake
AT+MCMTC2 Get/Set Serial port modbus tcp configuration
AT+MCIPM2 Get/Set Serial port IP protocol mode AT+MCTC2 Get/Set Serial port tcp client
configuration when IP protocol mode is TCP Client
AT+MCTS2 Get/Set Serial port tcp server configuration when IP protocol mode is TCP Server
AT+MCTCS2 Get/Set Serial port tcp client/server configuration when IP protocol mode is TCP Client/
Server
AT+MCUPP2 Get/Set Serial port UDP point to point configuration when IP protocol mode is UDP point
to point
AT+MCSMTP2 Get/Set Serial port SMTP client configuration when IP protocol mode is SMTP client
AT+MCPPP2 Get/Set Serial port PPP configuration when IP protocol mode is PPP
AT+MAEURD1 Get/Set Event UDP Report No.1
AT+MAEURD2 Get/Set Event UDP Report No.2
AT+MAEURD3 Get/Set Event UDP Report No.3
Continued...
ATL
Command Syntax
Lists all available AT Commands.
ATL <enter>
Description
Example