2 Equipment Installation
INSTALL THE VACUUM PUMP
Log in to your customer portal to access the Vacuum Pump Guide (part number 062-42804-00) for
instructions on installing the vacuum pump.
APPLY POWER TO THE ANALYZER
1. Toggle the power switch to the ON position.
2. Check the power indicator on the front panel of the analyzer. The indicator will blink green to
indicate that power is applied to the analyzer. Once the application is running, the indicator will
stop blinking and remain illuminated.
2 - 2
TriStar II 3020 Confirm Installation Instructions and Checklist
302-42870-04 (Rev A) — Sep 2017
To Next Page
Loading...
