6 Installation Checklists
Procedure
Evaluation Code
The analyzer has been connected to a power source?
P F N/A
Configure the Ethernet port
P F N/A
Connect computer to analyzer.
P F N/A
Connect theEthernet switch, if applicable.
l If one Ethernet based analyzer was purchased, connect the Ethernet cable
to the analyzer and the computer, or
l If more than one Ethernet based analyzer was purchased, connect an Eth-
ernet cable from the computer to the Ethernet switch. Then connect the Eth-
ernet based analyzers to the Ethernet switch.
P F N/A
Install application software.
P F N/A
Setup Computer
Device
Description
Computer
(make / model / SN)
Computer
Operating System
Printer
(make / model / SN)
Was the computer supplied by Micromeritics? Y N
Computer Information
Name:
Date:
Comments:
Computer Installed By:
6 - 2
TriStar II 3020 Confirm Installation Instructions and Checklist
302-42870-04 (Rev A) — Sep 2017
To Next Page
Loading...
