PDS-104G PoE Switch
Power Over Ethernet PowerView Pro User Guide
Copyright © 2016 Microsemi Page 10 of 48
Rev. 1.0 CPG – PoE BU
One Enterprise Aliso Viejo, CA 92656 USA
2.6.1 Web HTTP/HTTPS, Telnet/SSH – Username & Password
Web HTTPS/HTTPS, Telnet and SSH share the same username and password.
2.6.2 SNMP Security
SNMP v1/v2: Community string is utilized for Get/Set/Trap authentication. SNMPv1/v2 is considered
as unsecured protocol since the community string password can be easily intercepted by any network
sniffing device.
SNMP v3: Resolves SNMPv1/v2 security issues by adding authentication and encryption to layer on
top of SNMP packets.
2.7 Default unit IP, username and password
The unit is shipped with the following factory default usernames and passwords:
NOTE:
Default IP address:
IP = 192.168.0.50
Mask = 255.255.255.0
Web/Telnet:
Username = ”admin”
password = ”password”
SNMP v2:
GET community string =”public”
SET community string = "private"
SNMP v3:
user name =”admin”
authentication password (MD5) = ”password”
privacy password (DES)= ”password”
Username, password recovery:
For username and password recovery, whenever unit username or password were
changed and are unavailable to the user, please refer to Section 9, Recovering from Unknown
Username, Password.
To Next Page
Loading...