PDS-104G PoE Switch
Power Over Ethernet PowerView Pro User Guide
Copyright © 2016 Microsemi Page 29 of 48
Rev. 1.0 CPG – PoE BU
One Enterprise Aliso Viejo, CA 92656 USA
4.3 Telnet/SSH – Configuration and Maintenance Menu
Telnet/SSH Configuration and Maintenance Menu provides the option to enable/disable PoE ports (no effect on
Ethernet Link), upload/download unit configuration and perform software updates, various unit reset options,
and enable/disable auto ping to Default Gateway to ensure network connectivity.
NOTE:
Please refer to Sections 7 and 8 for a detailed description on how to upload/download the unit
configuration or perform software updates.
Figure 4-6: Telnet/SSH Configuration and Maintenance Menu
Enable/disable PoE port (Ethernet link remains enabled even when no
power is provided).
Download configuration file
from TFTP Server
Download unit configuration file from TFTP Server to the unit over the
network (please refer to Section 7 for more details).
After successful configuration download the internal Network Manager will
reset itself without affecting PoE functionality. However, network traffic
may be interrupted for several seconds while the internal Ethernet Switch
is reinitialized.
Upload configuration file to
TFTP Server
Upload unit configuration file from unit to TFTP Server over the network
(please refer to Section 7 for more details).
Download WEB SSL
Certificate from TFTP Server
Download from TFTP Server self-signed or CA signed certificates to the
unit to allow secure web browsing to the unit with security confirmation by
the Web Browser (green lock in the web browser URL area)
Performs software update the unit internal Network manager or update
PoE firmware. Software update is done by downloading the relevant new
files from TFTP Server (please refer to Section 8 for more details).
Network Manager updates - during the software update PoE functionality
will remain active. However, network traffic may be interrupted for several
seconds.
PoE Firmware update – PoE functionality will not be available during the
firmware update process (around 5-10 minutes)
Restore unit to factory default
(excluding IP configuration)
Restore unit configuration to factory default, leaving the IPv4/IPv6 network
configuration unchanged (as DHCP/Static IP, IP Address, etc.). Leaving
IP configuration unchanged maintains the option to access the unit over
the network as before.
To Next Page
Loading...
