Microsemi PDS-104G - SNMP Mibs; Copyright

PDS-104G PoE Switch
Power Over Ethernet PowerView Pro User Guide
Copyright © 2016 Microsemi Page 32 of 48
Rev. 1.0 CPG – PoE BU
One Enterprise Aliso Viejo, CA 92656 USA
SNMP security parameter
Default value
Comments
Get Community
public
SNMPv2C
Set Community
private
SNMPv2C
Trap Community
public
SNMPv2C Trap
User Name
admin
SNMPv3
Authentication Password
password
SNMPv3
Privacy Password
password
SNMPv3
Authentication and Encryption Mode
MD5+DES
SNMPv3
User Name
trap
SNMPv3 Notification
Authentication Password
password
SNMPv3 Notification
Privacy Password
password
SNMPv3 Notification
Authentication and Encryption Mode
None
SNMPv3 Notification
Table 5-1 Default SNMP usernames and passwords
2. Traps:
 To enable traps set remote manager IP address in the Remote IPv4/IPv6 SNMP Trap Managers
window. For SNMPv3 notifications/traps, make sure notification/trap username, authentication and
privacy password and encryption methods match your SNMP manager Trap Manager.
 To enable PoE traps (PoE port status changed, unit consumes over xy% of total unit power, or unit now
consumes less than xy% of total unit power), please enable PoE Notifications (see image below).
Figure 5-2: Enable SNMPv2, SNMPv3 and PoE traps
5.2 SNMP MIBs
Several MIBs are supported by SNMP manager.