EMC Standards
n AS/NZ 60950-1:2003
n PSE Japan
EMC Standards
Meets the following EMC standards:
n FCC Part 15 Subpart B
n 2004/108/ECCE EMC Directive
n EN61000-3-2:2000Harmonic Current
n EN61000-3-3:1995Voltage Fluctuations and Flicker
n EN55022:1998Conducted and Radiated Emissions Standard
n EN55024:1998Immunity Standard
n VCCI: April 2000Japan EMC Standard
n ICES-003Canada EMC Standard
n AS/NZS CISPR 22:2002Australia/New Zealand EMC Standard
Note: In some cases, for FCC and CE EMC Radiated Emission Compliance, a ferrite EMI
suppressor (Fair Rite P/N 0444164951 or equivalent) may need to be placed on the unit end
of cables connected to the BNC Connectors. Please contact Microsemi Customer Assist-
ance (on page 5) for additional information.
VCCI Compliance Information
This is a Class A product based on the standard of the Voluntary Control Council for Inter-
ference by Information Technology Equipment (VCCI). If this equipment is used in a
domestic environment, radio interference may occur, in which case the user may be required
to take corrective actions.
Listing of Memory Devices
The following devices contain either volatile or non-volatile memory:
ETX Module
n 512MB SDRAM. The 512MB Synchronous Dynamic RAM is installed on the ETX Mod-
ule in a DIMM socket. This part is used as system RAM memory for the ETX Module's
x86 processor. The content in this device is volatile and is lost when the SyncServer is
powered down. This part is socketed (ETX).
997-01520-02 Rev. F1.......................................................................... Page 129
To Next Page
Loading...
