Microsemi SyncServer S300 - How to Activate the PTP Option

PTP and NTP Performance
Management Message Name Actions Supported
FAULT_LOG_RESET NOT SUPPORTED
DEFAULT_DATA_SET GET supported
CURRENT_DATA_SET GET supported
PARENT_DATA_SET GET supported
TIME_PROPERTIES_DATA_SET GET supported
PORT_DATA_SET GET supported
PRIORITY1 GET supported
PRIORITY2 GET supported
DOMAIN GET supported
SLAVE_ONLY GET supported
LOG_ANNOUNCE_INTERVAL GET supported
ANNOUNCE_RECEIPT_TIMEOUT GET supported
LOG_SYNC_INTERVAL GET supported
VERSION_NUMBER GET supported
ENABLE_PORT COMMAND supported
DISABLE_PORT COMMAND supported
TIME GET supported
CLOCK_ACCURACY GET supported
UTC_PROPERTIES GET supported
TRACEABILITY_PROPERTIES GET supported
TIMESCALE_PROPERTIES GET supported
UNICAST_NEGOTIATION_ENABLE NOT SUPPORTED
PATH_TRACE_LIST NOT SUPPORTED
PATH_TRACE_ENABLE NOT SUPPORTED
GRANDMASTER_CLUSTER_TABLE NOT SUPPORTED
UNICAST_MASTER_TABLE NOT SUPPORTED
UNICAST_MASTER_MAX_TABLE_SIZE NOT SUPPORTED
ACCEPTABLE_MASTER_TABLE NOT SUPPORTED
ACCEPTABLE_MASTER_TABLE_ENABLED NOT SUPPORTED
ACCEPTABLE_MASTER_MAX_TABLE_SIZE NOT SUPPORTED
ALTERNATE_MASTER NOT SUPPORTED
ALTERNATE_TIME_OFFSET_ENABLE NOT SUPPORTED
ALTERNATE_TIME_OFFSET_NAME NOT SUPPORTED
ALTERNATE_TIME_OFFSET_MAX_KEY NOT SUPPORTED
ALTERNATE_TIME_OFFSET_PROPERTIES NOT SUPPORTED
DELAY_MECHANISM GET supported
LOG_MIN_PDELAY_REQ_INTERVAL GET supported
How to Activate the PTP Option
PTPin the 300 Series SyncServer can be activated at the time of purchase or at a later date.
This section describes PTPactivation after the SyncServer has left Microsemi.
997-01520-02 Rev. F1.......................................................................... Page 53