WIZARDS - 1st Setup
WIZARDS - 1st Setup
Microsemi strongly recommends using the 1st Setup to perform the initial configuration of the
SyncServer, which includes:
n Setting a new password.
n Configuring Password Recovery (optional).
n Configuring the IP address, hostname, and DNS for LAN1 (erases network settings for
all other network ports.
n Setting the local time zone (optional).
Also see:
n For STEP 1: Password Setup and STEP 1A: Password Recovery, also see ADMIN -
Users (on page 84).
n For STEP 2: LAN1 IP Address, Hostname and DNS Servers, also see NETWORK -
Ethernet (on page 32).
n For STEP 2A: Local Time Zone, also see TIMING - Time Zone (on page 61).
WIZARDS - NTP
Microsemi recommends using this wizard to perform an initial NTP configuration of up to 5
server associations.
To modify an existing NTP configuration, use the NTP - Config page instead.
Note: This Wizard deletes all NTP associations that are not server associations.
Also see: NTP - Config (on page 43) and NTP - MD5 Keys (on page 47).
WIZARDS - SNMP
Use the SNMP wizard to add or change the following SNMP v1/v2c settings:
n Set SysLocation, SysContact and SysName
n Set the Read and Write Community Strings
n Add up to four v1/v2c Trap Destinations
Advanced SNMP configuration (e.g., SNMP v3) is performed on the NETWORK - SNMP and
NETWORK - Traps pages. Upon completing the Wizard, the new SNMP settings replace the
previous ones and the SNMP daemon restarts.
See also NETWORK - SNMP (on page 35) and NETWORK - SNMP Traps (on page 37).
WIZARDS - Backup
The Backup wizard guides the operator through saving the SyncServer’s current con-
figuration to nonvolatile memory in the SyncServer, and optionally transfers the backup con-
figuration to a remote location. The backup file can be used to:
n 'Clone' the configuration to other SyncServers with the same Software Version.
n Restore the SyncServer's configuration if it is lost or becomes unusable.
997-01520-02 Rev. F1.......................................................................... Page 99
To Next Page
Loading...
