Tasks
n
Connect the VAC Input connector on the rear panel to a grounded three-prong outlet
using the standard power cord supplied.
CAUTION: VAC Power
n The VAC Power Supply specification reflects the overall Power Supply ratings. For UL
and CE compliance the Power Supply must only be operated at 100 – 240 VAC, 50-60
Hz.
n The SyncServer should only be plugged into a grounded receptacle.
ATTENTION :
n Les spécifications d'approvisionnement de courant alternatif ci-dessus reflètent les estim-
ations globales d'alimentation d'énergie. Pour la conformité d'UL et de CE l'alimentation
d'énergie doit être seulement opérée à 100 - 240 VCA, 50-60 hertz.
n Relier le SyncServer à une prise de courant avec contact adéquat de mise à la terre.
Electrical Installations in Norway and Sweden
For Electrical Installations in Norway and Sweden
Equipment connected to the protective earthing of the building installation through the mains
connection or through other equipment with a connection to protective earthing - and to a
cable distribution system using coaxial cable, may in some circumstances create a fire haz-
ard. Connection to a cable distribution system has therefore to be provided through a device
providing electrical isolation below a certain frequency range (galvanic isolator, see
EN60728-11).
Note: In Norway, due to regulation for installations of cable distribution systems, and in
Sweden, a galvanic isolator shall provide electrical insulation below 5 MHz. The insulation
shall withstand a dielectric strength of 1.5 kV r.m.s. 50 Hz or 60 Hz for 1 minute.
FÖR ELEKTRISKA INSTALLATIONER I NORGE OCH SVERIGE
Utrustning som är ansluten till skyddande jordning av bygginstallationer genom nätuttaget
samband eller genom annan utrustning med en anslutning till skyddande jordning-och en
kabel distributionssystemet använder koaxialkabel, kan i vissa fall framkalla brandfara.
Anslutning till en kabel distributionssystemet har därför tillhandahållas genom en anordning
som elektrisk isolering under en viss frekvensområdet (galvaniskt isolator, se EN60728-11).
Anmärkning: i Norge, till följd av förordningen för installationer av kabel distributionssystem,
och i Sverige, en galvaniskt isolator skall ge elektrisk isolering under 5 MHz. isolering skall
tåla ett dielektriskt av 1,5 kV r.m.s. 50 Hz eller 60 Hz för 1 minut.
ConnectingVDCPower
For units equipped with the optional 48 VDC power supply:
n Use a 14 amp DC circuit breaker in series with the DC power source. Do not connect the
unit directly to a DC power source without the breaker.
Page 138..........................................................................997-01520-02 Rev. F1
To Next Page
Loading...
