Microsemi SyncServer S300 - Page 187

Configuring SNMP
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"System clock offset from the selected source."
::= {ntpSystem 10}
ntpSysFreq OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"System clock frequency correction from ntpd."
::= {ntpSystem 11}
ntpSysError OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Current system error from ntpd."
::= {ntpSystem 12}
ntpSysClock OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Current system time from ntpd. This is usually
derived from the hardware clock but could be
from any other ntp source."
::= {ntpSystem 13}
ntpSysSystem OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..80))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Description of the current system."
::= {ntpSystem 14}
ntpSysProcessor OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Type of local processor."
::= {ntpSystem 15}
ntpSysNotrust OBJECT-TYPE
SYNTAX INTEGER (0..1)
ACCESS read-only
STATUS mandatory
997-01520-02 Rev. F1.......................................................................... Page 187