EasyManua.ls Logo

MidNite Classic - Page 62

MidNite Classic
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Classic Manual Rev L
61 | P a g e 1 0 - 0 0 1 - 1 R E V L
battery manufacturer’s specs (typically 85% for flooded, 90% for
sealed batteries).
Classic says “Arc Fault”
on the MNGP and is
making a loud beeping
noise
This generally indicates you have a bad connection somewhere
causing arcs. This can be anywhere in the system so finding it is
easier if you can turn things off and see what causes the fault to
clear.
This also can be caused by some AC loads powered off the
inverter, such as pumps or motors. Adjust the Arc Fault
sensitivity settings as required.
Classic keeps going
back to address 10
after I readdress it to
something else
There was a bug in older firmware that would cause this. We
recommend updating the firmware and doing a factory restore.
The firmware can be found on our website under the “Software”
tab.
I am having issues
connecting my Classic
directly to my PC
without a router
We advise against this as it is more complicated than most people
feel comfortable with. We recommend a cheap router for this as
it makes it much easier. The way to think about this is the
computer and Classic have NO address until the router addresses
them, so if you must go direct you have to address both of them.
To do a direct connection we recommend a crossover Ethernet
cable. Set the Classic to a static IP, say 192.168.1.5, then you need
to go into the IPV4 properties on the PC and set it for a static IP of
192.168.1.2, for example.
NOTE: The important part here is that the first 3 sets of numbers
match 192.168.1.xxx, for example, and that the LAST sets of
numbers do NOT match, as this is the unique identifier of where
each item is. You will not need to worry about Gateways or DNS
IPs for this connection. For more help with this see our video on
direct connection to Classic or consult your network guru.
I cannot find an
uninstaller for the
MidNite firmware
updater
Go to the C directory and find the folder labeled midnitesolar and
open it. In here you will find an uninstaller; double left click it to
run it. After it is completes, you can delete the midnitesolar folder
to completely remove any files left behind.
What is the
PASSWORD for the
Classic?
All Classics use 142 for the password.

Table of Contents

Related product manuals