MILACRON MFC-G - Table of Contents

Temperature Control Units : MFC with G Series Instrument
Page: 4
Milacron Process Support Business
4165 Halfacre Road Batavia, Ohio 45103
Phone: 513-536-2584
www.milacron.com
TABLE OF CONTENTS
1.0 GENERAL 9
1.1 Receiving Instructions 10
1.2 Introduction 10
1.3 Safety 10
1.4 Water Treatment 11
1.5 Components 11
2.0 INSTALLATION 13
2.1 General 14
2.2 To and From Process Connections 14
2.3 Water Supply Connection 15
2.4 Drain Connection 15
2.5 Electrical Connection 17
3.0 START UP SEQUENCE 21
3.1 General 22
3.2 Machine Start Up and Operation 22
3.3 Instrument : Quick Start 26
3.4 Instrument : Basic Navigation 27
3.5 Instrument : Operating Screens 29
3.6 Instrument : Fault Screens 30
3.7 Instrument : Main Menu 31
3.8 Instrument : Setpoints Menu 31
3.9 Instrument : Utilities Menu 33
3.10 Instrument : Network Menu 34
3.11 Instrument : Features menu 35
3.12 Instrument : Flow Menu (option) 38
3.13 Instrument : Options Menu 39
3.14 Instrument : Machine Menu 40
3.15 Shut Down - Disconnect 41
4.0 TROUBLESHOOTING 43
4.1 Unit Will Not Start (Display is not Illuminated) 44
4.2 Unit Will Not Start (Display Illuminated) 44
4.3 Unit Stops 44
4.4 Unit Overheats 45
4.5 Unit Underheats 46
4.6 Pressure Relief Valve Leaks 46
4.7 Cooling Valve Fault 47
5.0 MAINTENANCE 49
5.1 Pump Seal Replacement 50
5.2 Heating Cylinder Replacement 53
5.3 AVT
TM
Cooling Valve Service 56
5.4 Voltage Changeover 59
5.5 Sensor Probe Service 61
5.6 Pressure Switch Service 62
5.7 Electronic Instrument Repair Policy And Procedure 63
5.8 Temperature Probe Calibration 64
5.9 Heater Contactor and Pump Motor Starter 66