Miller Auto-Line Invision 352 MPa - Section 9 − Maintenance; Routine Maintenance; Blowing out Inside of Unit

TM-246193 Page 65
Invision 352 MPa
SECTION 9 − MAINTENANCE
9-1. Routine Maintenance
 Maintain more often during
severe conditions.
! Disconnect power
before maintaining.
 = Check  = Change  = Clean  = Replace
Every
3
Months
Replace
Damaged
Or
Unreadable
Labels
  
Replace Cracked
Torch Body
 
Repair Or
Replace
Cracked
Cables
 
Repair Or Replace
Cracked Cables And
Cords
 
Clean
And
Tighten Weld
Connections
 
Every
6
Months
Blow Out Inside
 
9-2. Blowing Out Inside Of Unit
! Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
Ref. 803691-E