EasyManua.ls Logo

Miller PipePro Series - Section 4 − Specifications; Serial Number and Rating Label Location; Weld, Power, and Engine Specifications; Dimensions, Weights, and Operating Angles

Miller PipePro Series
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Complete Parts List is available at www.MillerWelds.com
OM-262506 Page 20
SECTION 4 − SPECIFICATIONS
4-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on the front. Use rating label to determine input power requirements and/or rated
output. For future reference, write serial number in space provided on back cover of this manual.
4-2. Weld, Power, And Engine Specifications
This equipment will deliver rated output at an ambient air temperature up to 1045F (405C).
Engine
Generator Power
Rating
Welding Mode
Weld Output
Range
Rated Welding
Output
Maximum
Open-Circuit
Voltage
Fuel
Capacity
Mitsubishi
Water−Cooled
Four−Cylinder
24.4 HP Diesel
Engine
Single-Phase,
10 kVA/kW,
83/42 A,
120/240 V AC,
60 Hz
CC/DC
CV/DC
20 − 400 A
14 − 40 V
400 A, 24 Volts DC,
100% Duty Cycle
350 A, 27 Volts DC
100% Duty Cycle
300 A, 32 Volts DC
100% Duty Cycle
85*
11.5 gal
(43.5 L)
* With Low OCV switch (Voltage Reducing Device, VRD) enabled, open−circuit voltage is 13 to 15 volts DC until arc initiation.
4-3. Dimensions, Weights, And Operating Angles
Dimensions
Front Panel End
B
A
F
E
H
G
C
D
20°
20°
30°
30°
! Do not exceed tilt angles or engine could
be damaged or unit could tip.
! Do not move or operate unit where it could
tip.
907 428−1
Height
32 in. (813 mm)
35.75 in. (908 mm)
(to top of lift eye)
Width
26.25 in. (667 mm)
(mtg. brackets turned in)
28.75 in. (730 mm)
(mtg. brackets turned out)
Depth 56 in. (1422 mm)
A 56 in. (1422 mm)
B 54 in. (1372 mm)
C 52.25 in. (1327 mm)
D 2 in. (51 mm)
E 26 in. (660 mm)
F 7/8 in. (22 mm)
G 27.75 in. (705 mm)
H
9/16 in. (14 mm) Dia.
4 Holes
Weight
No fuel: 1018 lb (462 kg)
w/ fuel: 1100 lb (499 kg)
Lifting Eye Weight Rating:
2000 lb (907 kg) Maximum
4-4. Environmental Specifications
A. IP Rating
IP Rating
IP23S
This equipment is designed for outdoor use. It may be stored, but is not intended to be used outside during precipitation unless sheltered.
IP23S 2014−06
B. Temperature Specifications
Operating Temperature Range* Storage/Transportation Temperature Range
−40 to 104°F (−40 to 40°C)
*Output is derated at temperatures above 104°F (40°C).
−40 to 131°F (−40 to 55°C)
Temp_2016-07

Table of Contents