Miller PipePro Series - Table of Contents

TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS − READ BEFORE USING 1.................................
1-1. Symbol Usage 1.......................................................................
1-2. Arc Welding Hazards 1.................................................................
1-3. Engine Hazards 3......................................................................
1-4. Compressed Air Hazards 3..............................................................
1-5. Additional Symbols For Installation, Operation, And Maintenance 4.............................
1-6. California Proposition 65 Warnings 6......................................................
1-7. Principal Safety Standards 6.............................................................
1-8. EMF Information 6.....................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 7..........................
2-1. Signification des symboles 7.............................................................
2-2. Dangers relatifs au soudage à l’arc 7......................................................
2-3. Dangers existant en relation avec le moteur 9..............................................
2-4. Dangers liés à l’air comprimé 10...........................................................
2-5. Dangers supplémentaires en relation avec l’installation, le fonctionnement et la maintenance 11.....
2-6. Proposition californienne 65 Avertissements 13..............................................
2-7. Principales normes de sécurité 13.........................................................
2-8. Informations relatives aux CEM 13.........................................................
SECTION 3 − DEFINITIONS 15..................................................................
3-1. Additional Safety Symbols And Definitions 15................................................
3-2. Miscellaneous Symbols And Definitions 18..................................................
SECTION 4 − SPECIFICATIONS 20..............................................................
4-1. Serial Number And Rating Label Location 20..................................................
4-2. Weld, Power, And Engine Specifications 20...................................................
4-3. Dimensions, Weights, And Operating Angles 20...............................................
4-4. Environmental Specifications 20............................................................
4-5. Duty Cycle And Overheating 21.............................................................
4-6. Volt-Ampere Curves For All Models 22.......................................................
4-7. Fuel Consumption For All Models 23.........................................................
4-8. AC Generator Power Curve 23.............................................................
SECTION 5 − INSTALLATION 25................................................................
5-1. Installing Welder/Generator 25..............................................................
5-3. Installing Exhaust Pipe 26..................................................................
5-4. Connecting The Battery 27.................................................................
5-5. Engine General Information 28..............................................................
5-6. Engine Fuel And Coolant Prestart Information 28..............................................
5-7. Engine Oil Prestart Information 29...........................................................
5-8. Connecting To Weld Output Terminals 29.....................................................
5-9. Weld Output Terminals 30..................................................................
5-10. Selecting Cable Sizes* 32................................................................
5-11. Connecting To Remote 14 Receptacle RC14 32..............................................
SECTION 6 − OPERATING WELDER/GENERATOR 33.............................................
6-1. Front Panel Controls (See Section 6-2) 33....................................................
6-2. Description Of Front Panel Controls (See Section 6-1) 34.......................................
6-3. Process/Contactor Switch 35...............................................................
6-4. Arc Control 36...........................................................................
6-5. Low Open-Circuit Voltage (VRD) Switch Mode 37..............................................
6-6. Stick Start Procedure − Scratch Start Technique 37............................................
6-7. Lift-Arc TIG With Auto-Stop 38..........................................................