Miller PipePro Series - Overload Protection and Troubleshooting

 Complete Parts List is available at www.MillerWelds.com
OM-262506 Page 46
8-2. Routine Maintenance
! Stop engine before maintaining.
 See Engine Manual and Maintenance Label
for important start-up, service, and storage
information. Service engine more often if
used in severe conditions.
Recycle engine
fluids.
 = Check  = Change  = Clean  = Replace
* To be done by Factory Authorized Service Agent
Reference
Every
8
Hours
See engine
manual for fuel
specifications.
Section 5-6,
5-7
 Coolant Level  Fuel Level  Oil Level  Oil, Fuel Spills
Every
50
Hours
Clean unit exterior, includ-
ing stainless steel, fre-
quently to prevent rust and
corrosion.
 Weld Terminals
Every
100
Hours
Section 8-7
 Battery Terminals  Air Cleaner Hoses  Air Cleaner Element  Unreadable Labels
Every
500
Hours
SLUDGE
FUEL
1/2 in.
(13 mm)
Engine
Manual,
Section 8-8,
8-11
 Drain Sludge  Oil  Oil Filter
NOTICE − Change engine
oil and filter after initial 50 to
75 hours of use.
 Fan Belt Tension Spark Arrestor
 Weld Cables Radiator Thermostat  Fuel Filters
Every
1000
Hours
OR
Section 5-6,
8-9, and
Engine
Manual
 Slip Rings*
 Brushes*
Valve Clearance*  Inside Unit Radiator Fluid Level
Every
2000
Hours
 Injectors*
Mitsubishi Engine North America
1250 Greenbriar Dr., Suite E
Addison, IL 60101
630−268−0750
http://www.mitsubishi−engine.com
Use web site to locate closest dealer. For international
information, use: http://www.mhi.co.jp
8-3. Adjusting Engine Speed
NOTICE − The engine is electronically governed. Engine speed adjustment must be done by an engine Factory Authorized Service Agent. Tampering
with adjustments may affect engine warranty.