Complete Parts List is available at www.MillerWelds.com
OM-262506 Page 27
NOTICE − Lead acid batteries discharge
when stored in any temperature. Units that
are stored should have the battery
recharged every three months and before
being put into service. To preserve opti-
mum battery performance and life,
recharge battery in storage when the
open−circuit voltage drops to 12.4 volts
DC when measured across the battery
terminals.
! Connect negative (−) cable last.
NOTICE − Wait two minutes after engine
shutdown before disconnecting battery or
engine controller may be damaged.
Battery is accessed through the side door.
Connect battery, negative cable last.
Close side door.
Do not allow the battery cables to
touch opposing terminals. When connect-
ing the battery cables attach the positive
(+) cable to the positive (+) battery termin-
al first, followed by negative (−) cable to
negative (−) battery terminal.
Never start the engine when the
cables are loose or poorly connected to
the battery terminals.
Never disconnect the battery while
the engine is running.
Never use a quick battery charger to
start the engine.
Do not charge battery with Engine
Control switch On.
Always disconnect the negative (−)
battery cable before charging battery.
1/2 in.
−
+
Tools Needed:
Shown with door open and
rocker panel removed.
5-4. Connecting The Battery
Conn_Batt2 2014−11 / S-0756-C / 161-002
Notes
To Next Page