Millipore Milli-Q Integral 3 - Page 135

135
Summary of Alarm messages, Continued
Alarm
messages
(continued)
LCD message What it means
CLEANING CANCELLED
• A cleaning mode was cancelled
and was not fully completed.
• Go to STANDBY Mode and then
go to READY Mode.
• The Milli-Q System will go into a
15 minute FLUSH Mode. The
system will then automatically fill
the Reservoir.
ELIX PRODUCT R < SP
• The resistivity of the water filling
the Reservoir is < set point.
• Contact Millipore.
ELIX PRODUCT R > MAX
• The resistivity of the water filling
the Reservoir is out of
measurement range.
• Contact Millipore.
ELIX PRODUCT T < MIN
• The temperature of the water
filling the Reservoir is out of
measurement range.
• Contact Millipore.
ELIX PRODUCT T > MAX
• The temperature of the water
filling the Reservoir is out of
measurement range.
• Contact Millipore.
FLOW AUTO STOP
• The Milli-Q System has
automatically stopped dispensing
water. The POD FLOW STOP
timer has reached 0 minutes.
• Push the Q-POD Unit Plunger all
the way down and release.
• This resets the dispenser timer and
makes the Q-POD Unit available
for dispensing.
INCORRECT PROGARD PACK
• The Milli-Q System does not
recognise the type of Progard Pack
being installed.
• Contact Millipore.
INCORRECT QUANTUM
CARTRIDGE
• The Milli-Q System does not
recognise the type of Quantum
Cartridge being installed.
• Contact Millipore.
Continued on next page