MIMAKI CG-100SR2 - Page 25

24
Loading a sheet of media
Sheet detection
The width and length of the sheet are detected by pressing or key depending
on the sheet loaded. ( P.25)
• Once the sheet length has been detected, if the received data is larger than the sheet, the
portion of data that exceeds the sheet cannot be used for cutting.
If the sheet length is not detected, the plotter will terminate cutting operation when data goes
beyond the sheet.
• If the sheet sensor function is set to [OFF], a press of a jog key will make
the plotter perform the same sheet detection as the case key is pressed. (Only the
sheet width is detected.)
• The maximum length that can be detected at the
front and rear ends of the sheet of media is 3 m.
END
END
Origin after
detection
3 m maximum
When the tail end of
the sheet is detected