15
Installing a tool
For this device, you can use the following tools.
Cutter : Select this to cut the image printed on a sheet and to create the cut letters with
the cutting sheet.
Pen (rollerball) : Select this to “trial-write” for confirming how to actually cut.
Pouncing Pin (option) : Select this to sketch the cutting line.
Using a cutter
How to install a cutter
1
Remove the cap located at the edge by
rotating it.
2
Replace thecutter with a new one using
tweezers or the like.
3
Turn the adjusting knob to adjust the
protruding amount of the cutter.
• arrow to protrude the cutter blade.
( 0.5 mm per revolution)
• Don’t touch the cutter blade with your fingers.
->Sharp cutter tip may injure you.
• After setting the cutter, do not shake the cutter holder.
->The tip of the cutter may pop out and may injure you.
• Keep the cutter out of reach of children. Dispose of the used cutter blade in compliance
with the applicable regulations.
To Next Page
Loading...
