16
Installing a tool
Adjusting the protrusion of the cutter blade
Adjust the cutter blade according to the types of the cutters and the sheet for use.
After adjusting the protrusion of the cutter blade, set the cutting conditions and conduct test cutting to check
the cutting quality.
1
Turn the adjusting knob to adjust the
protruding amount of the cutter blade.
• arrow to protrude the cutter blade.
( 0.5 mm per revolution)
• Take care not to protrude the blade too much. If the cutter is used with its blade excessively
protruded, the cutter can cut out the base paper, thus damaging the main unit.
• See the operation manual for the blade adjustment of the cutters other than the auxiliary
products
To Next Page
Loading...
