MIMAKI CG-100SR2 - Set for Detecting the Registration Marks

43
Set for Detecting the Registration Marks
When you want to cut the data with registration marks, you must set the following without fail.
1
Press the key in the local
mode.
2
Press the jog key or to select
[SET UP] .
3
Press the key.
4
Press the jog key or to select
[MARK DETECT] .
5
Press the key.
6
Press the jog key or to select
[Number of detected registration
marks].
• Set values: OFF, 1pt, 2ptA, 2pt B, 3pt, and 4pt
7
Press the key.
• In case you selected “OFF” in Step 6, proceed to Step 12.
8
Press the jog key or to select the following items.
• The following items are provided for the setting of registration mark detection:
Scale compensation, registration mark size, offset A, offset B, form of registration mark,
number of continuous cutting in direction A, number of continuous cutting in direction B,
high speed limit and skew check
• See pages P.44 through P.47 for the contents of each setting item.
DATA CLEAR <ENT>
FUNCTION
SET UP <ENT>
ENTER/HOLD
MARK DETECT<en t >
MARK DETECT : OFF
ENTER/HOLD
MARK DETECT : 2p t A
ENTER/HOLD