MIMAKI CG-100SR2 User Manual

26
Loading a sheet of media
Loading a leaf sheet (cut sheet)
1
Press the key to switch to
NOT READY mode.
• You need not to do so if it’s already in the NOT
READY mode.
Start operation from the Step 2.
2
Load the leaf sheet on the platen.
(1) Move down the clamp lever to the rear and raise the
pinch rollers.
(2) Set the right end of the sheet considering the platen
vertical rib as the measure.
Or, align the near end of the sheet in parallel with the
platen.
3
Move the pinch rollers so that they suit
the sheet width.
• Locate each of the pinch rollers 5 mm or more
inside the sheet edge; otherwise, the sheet can
slip off the pinch rollers while it is being fed.
4
Move down the clamp lever to the front
and move the pinch rollers down.
ROL L < R > LEAF
SHEET SET
Vertical rib

MIMAKI CG-100SR2 Specifications

General

Brand	MIMAKI
Model	CG-100SR2
Category	Cutter
Language	English