Chapter 5 Troubleshooting
5-6
When media heaves up at feeding
We call the status of heaving media at feeding “cockling”.
When media cockling occurs, check the following items:
Note/ checking items Measures
Checking media set status
(1) Check that the media is set straight and reset it.
Adjusting heater temperature
(1) Upper pre-heaters’ temperatures.
Media feeding
(1) For roll media, feed the media by about tens of centimeters to one
meter.
(2) For leaf media, press [][] and perform feed/ back feed.
Do not leave the media in the heater warming
status
(1) Do not start printing with the media cockled because it may cause
media jam.
Heighten the head
(1) For the thick media, make the head gap higher before printing.
To Next Page
Loading...
