MIMAKI SWJ-320EA - Replacing the Mist Fan Filter (H Fan Filter)

4-20
Chapter 4 Maintenance
7
Insert a new wiper.
• Insert a new wiper by holding its both ends.
• There is no direction to the wipers. They can be
inserted with either side facing forward.
8
Close the right side maintenance cover
and press the key.
• After its initial operation, the machine returns to
Local.
Replacing the Mist Fan Filter (H fan
filter)
Replace it once a month.
1
Press the
(TEST PRINT/CLEANING)
,
and press the key in Local.
2
Press to select “Station”, and
press the key.
• The Station MENU appears.
3
Press to select “CARRIAGE
OUT”, and press the key twice.
• The carriage moves onto the platen.
4
Open the right side maintenance cover.
(1) Rotate the screws under the right side
maintenance cover (for two positions) to the
left and remove them.
(2) Hold the bottom of the right side
maintenance cover and pull it to the front.
(3) While pulling the right side maintenance
cover downward, remove it.
• If the right side maintenance cover is hard to
remove, use the supplied screwdriver.
5
Remove the H fan filter cover at the right
side of the carriage.
• Remove the screw on the H fan filter cover before
removing the cover.
6
Remove the used H fan filter cover.
Carriage
Right side
maintenance cover
Screw
H fan filter cover
Claw
H fan filter
H fan filter cover