AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever in
the font of this machine.
Main power switch
Turns on/off the main power for this machine.
Leave the main power turned on to prevent ink
clogging.
Roll holders
Uses when printing a media of vinyl
chloride or photo paper.
Pre-heater
Preheats the media before printing. (Located inside the cover)
Rear cover
Open the cover in setting of medias, taking of measures
against jamming of medias. Even when the power button is off,
keep this cover and the other covers closed.
Tension bar
Brings tension to the media.
Ink supply unit
Set the ink tank.
Wide media set area (2 bars)
Set a wide media.
Feweding Manual switch
Changes the feeding
method (AUTO/MANUAL).
Feeding direction switch
Changes the feeding direction
(Forward/Backward/OFF).
LAN connector
This is Ethernet interface
connector.
USB 2.0 connector
This is USB2.0 interface
connector.
To Next Page
Loading...
