4-18
Chapter 4 Maintenance
For waste ink remaining management
In this machine informing the remaining amount of the waste ink tank (as a guide) on the display.
For the operation limitation by the amount of waste ink
According to the amount of waste ink that has accumulated in the waste ink tank, there are items that will not be able to
operate in this machine.
Discarding waste ink diligently is recomended.
Error Message Operation restriction Solution
No
It can be used as they are, but waste ink
tank would be immediately full.
Dispose the waste ink as soon as possible.
Dispose of waste ink according to regional
laws and regulations.
Following operations will not be
activated.
• Operation using ink
•Print
• Remote transition
• If occurs during printing, transit to
local after printing completion
Replacing the waste ink tank referring to
the manual Chapter 4 "Discarding waste
ink"
Then, please reset the waste ink tank.
Dispose of waste ink according to regional
laws and regulations.
REMOTEMENU
TEST PRINT /
CLEANING
3200mm
Local <Setup 1>
PRE PRINT POST
30°/40°30°/35°40°/50°
Amount of waste ink
0-9% of the waste ink has accumulated in the
tank
10-29% of the waste ink has accumulated in
the tank
30-49% of the waste ink has accumulated in
the tank
50-69% (NEAR FULL)
Waste ink is nealy full. Recommend to discard
as soon as possible.
70%- (FULL)
Waste ink tank is full. Dispose waste ink
promptly.
REMOTEMENU
TEST PRINT /
CLEANING
WASTE INK NEAR FULL
Local <Setup 1>
PRE PRINT POST
30°/40°30°/35°40°/50°
REMOTEMENU
TEST PRINT /
CLEANING
WASTE INK FULL
Local <Setup 1>
PRE PRINT POST
30°/40°30°/35°40°/50°
To Next Page
Loading...
