Chapter 1 Before Use
1-7
1
2
2
2
2
Heater
Pre-heater, Print heater, and Post-heater are equipped on
the platen. Pre-heater is used for pre-heating of the media
prior to printing. Print-heater is improves the image quality
in printing. Post-heater is dries ink after printing.
Media sensor
The media sensor detects the presence of the media.
This machine has three media sensors on the pre-heater
cover (in the rear).
Carriage
The carriage has the ink head for printing.
• During the heating by the pre-heater, the pre-
heater cover is hot on the backside of this
machine. Before opening the backside cover or
changing the media, allow the pre-heater to cool
down sufficiently. Failure to do so may cause a
burn injury.
• Before changing the existing media with a thin
media, allow the pre-heater to cool down
sufficiently. If such a change is made while the
pre-heater cover is hot, the thin media might stick
fast to the platen, or get wrinkled or curled.
• If the media floats as wave, press the [] button
on the operation panel to feed the media.
Pre-heater cover
Pre-heaterPrint heaterPost heater
• When setting a media, be sure to cover one of the
media sensors located on the rear of the pre-
heater cover. The media cannot be detected
unless it is placed over the sensor.
• When using twin rolls, set each of the media in
such a manner as to cover over each of the two
sensors located near the center of the pre-heater
cover. Otherwise, this machine might be
damaged.
To Next Page
Loading...
