MIMAKI SWJ-320EA - Changing the Printing Origin

2-17
2
2
2
2
3
Pull out so that the white plastic collar is
inserted into the slot on top of the leg.
4
Remove the roll holder, and take off the
paper core.
Changing the printing origin
The position of the printing origin can be changed.
1
In Local, press .
• It enters into the origin setting mode.
2
Press to set the origin
to a desired position.
• Select the carriage and media, moving the point
with [][][][]. (Position of the LED pointer
becomes the origin position.)
3
After determining the origin, press the
key.
• The printing origin is changed.
Origin Setup
Y
0.0
X
0.0
Origin
(Length)
Origin
(Width)
• When a roll media is set on the narrow roll holder,
change the origin, and then rewind the media by
hand and set the media without slack.
If the media is loose, the media feed amount of the
media varies, causing poor image quality.