Disassembly Instructions Repair Information
3 - 16 0070-10-0705 Passport V™ Service Manual
3.5.17 Removal of the Recorder Cover (if needed)
1. Pry up the recorder cover with a flat-bladed screwdriver.
FIGURE 3-26 Remove the recorder cover
3.5.18 Removal of the Main Frame and Multi-parameter Board Assembly
1. Remove the front housing assembly as stated in “Removal of the Front Housing
Assembly” on page 3-4.
2. Remove the recorder assembly (if installed) as stated in “Removal of the Recorder
Assembly” on page 3-15.
3. Disconnect the power switch cable from the interface board.
4. Remove the eight screws that secure the main frame and multi-parameter board
assembly to the rear housing.
FIGURE 3-27 Remove the screws and cables from the main frame
To Next Page
Loading...