Mindray Passport V - Removal of the Parameter Front Panel Assembly

Disassembly Instructions Repair Information
3 - 12 0070-10-0705 Passport V™ Service Manual
3.5.10 Removal of the Parameter Front Panel Assembly
1. Remove the multi-parameter board assembly as stated in “Removal of the Multi-
parameter Board Assembly” on page 3-10.
2. Unplug the tubing from the NIBP connector.
FIGURE 3-15 Unplug the tubing from the NIBP connector
3. Unfasten the two screws that secure the SpO
2
connector and then remove the connector
(if Masimo or Nellcor SpO
2
module is configured).
4. Remove the three screws that secure the parameter front panel.
5. Remove the parameter front panel.
FIGURE 3-18 Remove the parameter front panel
FIGURE 3-16 Masimo SpO
2
FIGURE 3-17 Nellcor SpO
2