Mindray Passport V - Removal of the Li-Ion Battery Interface Board Assembly

Passport V™ Service Manual 0070-10-0705 3 - 21
Repair Information Disassembly Instructions
6. Disconnect the power socket cable from the power board.
7. Remove the four screws that secure the power board.
8. Remove the power board.
FIGURE 3-37 Remove the power board
3.5.23 Removal of the Li-ion Battery Interface Board Assembly
1. Remove the front housing assembly as stated in “Removal of the Front Housing
Assembly” on page 3-4.
2. Remove the recorder assembly (if installed) as stated in “Removal of the Recorder
Assembly” on page 3-15.
3. Remove the two screws that secure the recorder connecting board and then remove the
board.
FIGURE 3-38 Remove the screws securing the recorder connecting board