To Next Page

To Previous Page

5-12 T1 Service Manual

5.4.5.2 Battery Performance Test

1. Turn off the monitor. Disconnect the monitor from the external power supply if DC adapter or T1 docking station is

connected.

2. Install the battery in the monitor. Connect the external power supply and allow the battery to be charged

uninterruptedly till it is fully charged.

3. Disconnect the external power supply. Remove the battery from the monitor. Keep the battery in room temperature for

two hours.

4. Allow the monitor to run from the battery until the battery is completely depleted and the monitor automatically shuts

off.

The operating time of the batteries reflects their performance directly. If the operating time of a battery is noticeably shorter

than that stated in the specifications, replace the battery.

5.4.6 Network Print Test

Note

 Use the recommended printers specified in the operator’s manual (PN: 046-006734-00).

Tools required:

 Hub and network cable

1 Connect the patient monitor and network printer to a HUB using common network cables as follows:

2 Set IP address as follows: Select [Main Menu]→ [Maintenance >>]→ [User Maintenance >>]→ enter the required

password→ [Network Setup >>]→ [Monitor Network Setup >>], set the IP address of the patient monitor in the

same network segment with that of the network printer. (See the instructions for use accompanying the printer)

3 Search for printer by selecting [Main Menu]→ [Print Setup >>]→ [Printer Setup >>]→ [Search Printer]. After a

while, the printer’s model and IP address will appear in the box beside [Printer].

Monitor Network printer

HUB

Cable

Mindray T1 Service Manual

Other manuals for Mindray T1