Mindray T1 - Disassembling the Right Housing Assembly

T1 Service Manual 7-13
7.4.1 Disassembling the Right Housing Assembly
Remove the four white covers over the screws, unscrew the four M3×8 screws and take out the right housing assembly.
7.4.1.1 Removing the Rotating Plate
Unscrew the four M3×8 screws and take out the right housing strengthen board. Then remove the rotating plate from the
right housing.
Unscrew the four
M3×8 screws
Unscrew the four
M3×8 screws
Remove the four
white covers over
the screws