Mindray T1 - Removing the Converter Board

7-14 T1 Service Manual
7.4.2 Removing the Converter Board
Unscrew the six M3×6 screws that attach the converter board pressing plate and then take it out.
7.4.2.1 Removing the Converter Board PCBA
Take out the converter board PCBA cable and converter board PCBA from the top housing. Then remove the connector from
the socket of converter board PCBA.
Remove the connector
from the socket of
converter board PCBA.
The ESD insulator is not
required to be removed
Unscrew the six
M3×6 screws