Probes and Biopsy 13-27
NGB-036
13.2.2 Basic Procedures for Biopsy Guiding
1. Select the correct needle-guided bracket and needle and install them properly. For details, see
“13.2.3 Needle-Guided Bracket Inspection and Installation.”
2. Verify the biopsy guide line. See chapter “13.2.6 Verifying the Biopsy Guide Line” for details.
3. Tap [Biopsy] to enter the biopsy.
Tips:
If the current probe has no corresponding bracket, or the image is frozen and the guide
line was hidden before the image was frozen, then you cannot enter the Biopsy menu.
Before entering the Biopsy menu, the system will display the prompt “Please verify
guidelines before biopsy.”
4. Select the bracket and guide line according to the actual situation.
5. In the Biopsy menu, tap [Alignment] to enter the Verify menu to verify the guide line. After
verification, tap [Save] to save the parameter setting. Then tap [Exit] to return to the Biopsy
menu.
Tips:
If you changed the probe or needle-guided bracket during the biopsy, verify the guide line
again.
When exiting the Verify menu without saving, the system will display the prompt “Data
have changed. Do you want to save the changes?” Tap [Yes] to save the setting and return
to the Biopsy menu.
6. Scan to locate the target. Center the target in the electronic guide zone path.
7. Direct the needle into the area of interest for specimen.
8. After extracting the biopsy sample, gently remove the probe from the body.
To exit the Biopsy menu: tap [Biopsy].
9. Disassemble the items and properly dispose of these items as required.
To Next Page
Loading...
Need help?
General
