6. Operating | 6.2 - Configuration and adjustment via the keypad | 102
Cd 005 appears on the display.
37. Press "OK".
uVolt.d appears on the display.
38. Press "OK".
The measuring signal in µV/d appears on the display.
39. Press "OK".
Cd 006 appears on the display.
40. Press "OK".
WEIGHt appears on the display.
41. Press "OK".
The measuring signal as weight value appears on the display (the
weight unit flashes).
Saving and exiting
42. Press "Exit".
SAVE appears on the display.
43. Press "OK".
yES appears on the display.
44. If necessary, press to select no.
45. Press "OK".
SAVE ... appears on the display while saving is in progress.
46. Press "Exit" to exit the setup menu.
47. If the metrology parameters CP 010 - CP 023 do not need to be set/have
already been set, the CAL switch must now be closed, see ChapterCAL
switch.
To Next Page
Loading...
