3. Device description | 3.3 - Housing | 25
3.3.4.2 Table-top device
In principle, the cables can be fed through all the cable glands that match the
cable diameter. The figure below shows a cabling suggestion.
Pos. Connection Description
1 Analog weighing electronics Analog weighing platforms and analog load cells
can be connected (via a cable junction box).
2 Grounding terminal The equipotential bonding conductor can be con
nected here.
3 CAL switch Access to the CAL switch on the mainboard
4 1 analog output The analog output can be used to control valves, for
example.
4 Fieldbus interface:
– ProfiBus-DP
– DeviceNet
– ProfiNet I/O
– EtherNet/IP
The corresponding device can be included under a
communication master (e.g. Siemens S7 ProfiBus)
as a fieldbus slave.
5 Supply voltage connection U
DC
= 24V
To Next Page
Loading...
