Minolta CR-400 - SIP;SOP Connections; Changing to PC Mode

50
Measuring Head 1
Functions
3,5
POWER
PC
RS-232Ccable
CR-A102
12
4
<Changing to PC Mode>
[Operating Procedure]
1
Turn the power OFF ( O ) and connect the instrument to the PC using the RS-232C
cable.
2
Turn the power ON ( I ).
RS-232C terminal
SIP/SOP Connections
• Accessories equipment connected the analog and digital interfaces must be certified to the respec-
tive IEC standards ( i.e. IEC950 for data processing equipment.)
• Furthermore all configurations shall comply with the system standard IEC 1010-1, Everybody who
connects additional equipment to the signal input part or signal output part configures a electrical
equipment for measurement system, and is therefore, responsible that the system complies with the
requirements of the system standard (IEC 1010-1. If in doubt, consult the technical services depart-
ment or your local representative.)