129
Data Processor
Functions
[Operating Procedure]
1
Turn the power OFF ( O ).
2
Connect the instrument to the PC us-
ing the RS-232C cable.
3
Turn the power ON ( I ).
<Changing to Remote Mode>
RS-232C terminal
Power switch
SIP/SOP Connections
• Accessories equipment connected the analog and digital interfaces must be certified to the respec-
tive IEC standards ( i.e. IEC950 for data processing equipment.)
• Furthermore all configurations shall comply with the system standard IEC 1010-1, Everybody who
connects additional equipment to the signal input part or signal output part configures a electorical
equipment for measurement system, and is therefore, responsible that the system complies with the
requirements of the system standard (IEC 1010-1. If in doubt, consult the technical services depart-
ment or your local representative.)
RS-232C
cable
CR-A 102
PC
2
1,3
To Next Page
Loading...
