69
Data Processor
Preparation
Adjusting the Contrast of the LCD
Adjust the brightness of the LCD display to the most appropriate level.
1
Turn the display contrast adjustment dial on
the right side of the data processor so that
the display is the most appropriate level.
• Turning it towards 1 makes the display darker and
towards 2 makes it lighter.
Setting this with low batteries may make the display difficult to see after measurement. Turn
the dial so that the display is the most appropriate level. (Replace the batteries as soon as
possible.)
[Operating Procedure]
1
2
Attaching the shoulder strap
Only customers who purchased the optional shoulder strap should refer to this.
The shoulder strap is attached to the instrument as follows.
1
Pass the strap through the shoulder strap
attachment.
2
Pass the strap back through, as shown in the
figure at right.
[Operating Procedure]
To Next Page
Loading...
