67
Data Processor
Preparation
Paper lock lever
Inserting the Roll Paper
Notes on Use
The data processor has a thermal printer which does not require an ink ribbon. Printed data may
become difficult to read because of the way the paper has been stored. Use new roll paper whenever
possible. We recommend you copy any data for long-term storage immediately after it has been printed.
[Operating Procedure]
1
Cut the edge of the roll paper as shown in the figure and pull out.
2
Open the paper chamber cover.
3
Slide the roll paper cut holder in the
direction of the arrow and then remove
it.
4
Move the paper lock lever to OPEN.
Roll paper cut holder
To Next Page
Loading...
