FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09
D-30
•
Adjustment of the Scanner Motor Timing Belt
3-3. ADJUSTMENT OF BELT TENSION
1. Remove the Original Glass.
2. Remove four screws and the Cover.
1167D014AB
3. Loosen the two screws that secure the Scanner
Motor. Using a bar tension gage, pull the motor to
the right with a tension of 1000 g ±50 g and, at the
same time, tighten the mounting screws.
NOTE
After the adjustment, turn the timing belt to check that
the belt teeth are in mesh with the pulley grooves.
1167D109AB
To Next Page
Loading...
