FrameMaker Ver.5.5E(PC) Di350 GENERAL, MECHANICAL/ELECTRICAL
98.12.18
G-11
1171SBG0400A
To ensure that the copier is used in an optimum condition, observe the following precau-
tions.
•
Never place a heavy object on the copier or subject the copier to shocks.
•
Insert the power plug all the way into the outlet.
•
Do not attempt to remove any panel or cover which is secured while the copier is making
copies.
•
Do not turn OFF the Power Switch while the copier is making copies.
•
Provide good ventilation when making a large number of copies continuously.
•
Never use flammable sprays near the copier.
•
If the copier becomes inordinately hot or produces abnormal noise, turn it OFF and
unplug it.
•
Do not turn ON the Power Switch at the same time when you plug the power cord into the
outlet.
•
When unplugging the power cord, do not pull on the cord; hold the plug and pull it out.
•
Do not bring any magnetized object near the copier.
•
Do not place a vase or vessel containing water on the copier.
•
Be sure to turn OFF the Power Switch at the end of the workday or upon power failure.
•
Use care not to drop paper clips, staples, or other small pieces of metal into the copier.
Operating Environment
The operating environmental requirements of the copier are as follows:
•
Temperature: 10°C to 32°C with a fluctuation of 10°C per hour
•
Humidity: 15% to 85% RH with a fluctuation of 10% RH per hour
Power Requirements
The power source voltage requirements are as follows:
4 PRECAUTIONS FOR USE
•
Voltage Fluctuation: AC120/230V
±10% (Copying performance assured)
+10%
-15%
(Paper feeding performance assured)
•
Frequency Fluctuation: 50/60 Hz ±0.3%
To Next Page
Loading...
