FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09
D-54
NOTES
•
If the Imaging Cartridge is not to be replaced after the Master Board has been replaced
with a new one, be sure to remount the EEPROM (IC3A) from the old to new Master
Board.
•
If the Master Board has been replaced with a new one and the EEPROM (IC3A) has not
been remounted, be sure to replace the Imaging Cartridge with a new one. Because the
EEPROM contains no data in this case, make settings and readjustments as necessary.
1. Remove the Master Board. (For details, see 2-2. REMOVAL OF CIRCUIT BOARDS
AND OTHER ELECTRICAL COMPONENTS.)
2. Demount the EEPROM (IC3A) from the new Master Board.
3. Demount the EEPROM (IC3A) from the old Master Board and remount it onto the new
Master Board.
4-2. REMOUNTING THE EEPROM (IC3A)
1171D048AA
New Master Board
New EEPROM
Old Master Board
Old EEPROM
NOTE
Note the alignment notch on the EEPROM (IC3A)
when mounting the IC.
1171D049AA
A
A
To Next Page
Loading...
