FrameMaker Ver.5.5E(PC) Di350 GENERAL, MECHANICAL/ELECTRICAL
98.12.18
G-12
1171SBG0500A
Before using any consumable, always read the label on the container carefully.
•
Use the right toner. The applicable copier model name is indicated on the toner bottle.
•
Paper is easily damaged by dampness. To prevent absorption of moisture, store paper,
which has been removed from its wrapper but not loaded into the drawer, in a sealed
plastic bag in a cool, dark place.
•
Keep consumables out of the reach of children.
•
Do not touch the PC Drum with bare hands.
•
Store the paper, toner, and other consumables in a place free from direct sunlight and
away from any heating apparatus.
•
The same sized paper is of two kinds, short grain and long grain. Short grain paper
should only be fed through the copier crosswise, long grain paper should only be fed
lengthwise.
•
If your hands become soiled with toner, wash them with soap and water immediately.
•
Do not throw away any used consumables (PC Drum, starter, toner, etc.). They are to be
collected.
NOTE
Do not burn, bury in the ground, or throw into the water any consumables (PC Drum,
starter, toner, etc.).
1171SBG0600A
The Print Head Unit of this copier uses a laser diode that emits a laser beam. Use the fol-
lowing precautions when performing service jobs at the users’ premises.
•
When a service job needs to be performed in the laser beam path, such as when working
around the Print Head Unit and PC Drum, be sure first to turn the copier OFF.
•
If the job requires that the power cord be left plugged in, observe the following precau-
tions
1. Take off your watch, ring, and any other reflective object and wear laser protective gog-
gles.
2. At the job site, select a place that is as far as possible away from the users and that is
enclosed by walls.
3. Do not bring a highly reflective tool into the laser beam path during the service job.
5 HANDLING OF THE CONSUMABLES
6 OTHER PRECAUTIONS
To Next Page
Loading...
